Part #101 Universal Collar
Fits most U.S. (Small, Medium or Heavy), Canadian or Mexican T-post. It is locked in place between lugs by Heavy Wedge #102. Collar accepts and holds bracing sockets and accessories. These can be attached on all 4 sides of collar.

Part #102 Heavy Wedge
Slip over rear flange of post and slide inside collar to hold collar in place. If using older Canadian T-posts with flat fronts, use a 1/4" bolt to secure to post. Please note there are no longer any tabs on the lower back of the wedge.

Part #106 60 Degree Socket
This socket attaches to collar, accepts and holds in place T-post used for diagonal brace. May also be used to brace wooden post with T-post.

Part #107 90 Degree Socket
This socket attaches to collar, accepts and holds in place T-post used for horizontal brace. May also be used to brace wooden post with T-post.

Part #115 - Gate Hinge
Allows you to hang a lightweight gate on a T-post up to 10'. Length of gate depends on type of brace supporting gate post.  A drive through gate needs a corner style brace so the gate post has support when swinging gate in that direction.

Part #116 Universal Bracket
can be used as a hot wire holder (with insulator insert), for making a shed roof, mounting a mail box or bird house, etc, just by bending to the needed angle.

Part #117 Supa-tube
insulator insert for hot wire.

Part #119 2x4/2x6 Holder
Makes a framework for t-post shed roofs and to make workbenches, racks, etc..

Part #120 Plywood Holder
For placing plywood siding on t-post sheds...(reverse for holding the top of the board).